How To Install
No tools, no plumber, no guesswork. Your Lucinn Pro is ready in minutes.
How It Works in Minutes
No tools, no plumber, no guesswork.
-
1
Remove your old showerhead.
Turn it counterclockwise by hand until it comes off the arm.
-
2
Screw on Lucinn Pro.
Turn it clockwise until hand tight. Fits standard ½" shower arms.
-
3
Turn on the water and enjoy.
Let it run for a minute, then step in and feel the difference.
Detailed Guides
Pick a guide below for a full walkthrough of your model.
Showerhead Installation
2 guidesWall Mounted Lucinn Pro Wall Mounted Installation Guide
Handheld Lucinn Pro Handheld Installation Guide
Filter Cartridge Replacement
2 guidesWall Mounted Lucinn Pro Wall Mounted Cartridge Replacement Guide
Handheld Lucinn Pro Handheld Cartridge Replacement Guide
Adjust and Tighten Joint
1 guideWall Mounted How to Adjust and Tighten the Rotating Ball of the Lucinn Pro Wall Mounted Filtered Showerhead
Something not quite right?
Unscrew the showerhead, make sure the rubber washer inside is sitting flat, then screw it back on until hand tight.
Check that nothing from your old showerhead was left in the arm, and that the washer is not folded over the inlet.
This is common as the filter media settles. Let the water run a little longer and it should clear.
See the Adjust and Tighten Joint guide above for a quick fix on the rotating ball.
Installation FAQ
Will it fit my shower?
Lucinn Pro fits standard ½" shower arms, which most US homes have. If your current showerhead screws on and off, you are almost certainly good to go.
Do I need to turn off the main water supply?
No. Just make sure the shower is switched off while you swap heads.
Can I install it in a rental?
Yes. Keep your old showerhead somewhere safe and you can switch it back in minutes when you move out.
How do I replace the filter?
Open the Filter Cartridge Replacement guide for your model in the Detailed Guides above.
Still stuck? We are happy to help.
Send us a photo of your setup and our team will walk you through it.